Show simple item record

dc.contributor.advisor Khlystov, Andrey en_US
dc.contributor.author Saleh, Rawad en_US
dc.date.accessioned 2011-01-06T16:00:35Z
dc.date.available 2011-01-06T16:00:35Z
dc.date.issued 2010 en_US
dc.identifier.uri http://hdl.handle.net/10161/3072
dc.description Dissertation en_US
dc.description.abstract <p>We have developed and applied novel experimental techniques for determination of thermodynamic and kinetic properties of semi-volatile organic aerosols. The thermodynamic properties investigated were the saturation pressure, enthalpy of vaporization and activity coefficient, and the kinetic property was the evaporation coefficient.</p><p>The thermodynamic properties were determined using the integrated volume method (IVM), which relies on measurements of aerosol particle concentrations at different thermodynamic equilibrium states. The measured decrease in particle concentration upon heating in a flow tube, a thermodenuder, can be correlated with saturation pressure and enthalpy of vaporization via the IVM equation, which was derived from fundamental principles, namely the Clausius-Clapeyron relation, mass conservation, and ideal gas law. The main advantage of the IVM over other methods reported in the literature is that the other methods use kinetic-based techniques to measure thermodynamic properties which requires assumptions on the usually unknown evaporation coefficient; the IVM, on the other hand, is equilibrium-based and thus requires no assumption on the evaporation coefficient. We have applied the IVM to C-4, -6, -7, and -9 dicarboxylic acid aerosols, which are pertinent to atmospheric secondary organic aerosols. Saturation pressure and enthalpy of vaporization values obtained for these compounds were respectively 3.7E-4 Pa and 88 kJ/mol, 3.4E-5 Pa and 135 kJ/mol, 7.2E-5 Pa and 149 kJ/mol, and 1.4E-5 Pa and 145 kJ/mol. </p><p>The IVM was also used to determine activity coefficients of individual compounds in binary mixtures as a function of their mole fractions. We demonstrated this method using the following four model systems. System 1: adipic acid - pimelic acid, which illustrated polar organic - polar organic interactions. Non-ideal behavior was observed with activity coefficients around three at infinite dilution. System 2: adipic acid - dioctyl sebacate, which illustrated polar organic - non-polar organic interactions. The compounds in this experiment did not form a solution. System 3: adipic acid - ammonium sulfate, which illustrates polar organic - inorganic interactions. The compounds in this experiment did not form a solution. System 4: adipic acid - ambient extracts, which illustrated the potential use of the method to study partitioning behavior of individual components in a complex matrix approximating that of real ambient aerosol. The measured activity coefficient of adipic acid was less than unity for the tested range of mixing ratios, indicating suppression of volatility of this compound in ambient organic matrix.</p><p>We have investigated three controversial issues associated with the IVM as well as other methods which utilize thermodenuders and/or aerosol generation by spray atomization and drying: 1) equilibration time scales in thermodenuders, 2) the need of an activated carbon (AC) denuder in the cooling section, and 3) the effect of residual solvent on measured thermodynamic properties of aerosols generated by spray atomization and drying. Both numerical simulations and experiments showed that the aerosols approached equilibrium within reasonable residence times (15 s - 30 s) for aerosol size distributions typical for laboratory measurements. We have also performed dimensional analysis on the problem of equilibration in TDs, and derived a dimensionless equilibration parameter which can be used to determine the residence time needed for an aerosol of given sized distribution and kinetic properties to approach equilibrium. Using both model simulations and experiments, we have shown that with aerosol size distributions relevant to both ambient and laboratory measurements re-condensation in the cooling section, with and without an AC denuder, was negligible. Thus, there is no significant benefit in using an AC denuder in the cooling section. To investigate the effect of residual solvent on measured thermodynamic properties, we compared measurements of saturation pressure and enthalpy of vaporization of C-6 (adipic) and C-9 (azelaic) dicarboxylic acid aerosols generated by atomization of aqueous solutions to those generated by homogeneous condensation using a modified Sinclair - La Mer generator. We found no statistically significant difference between the tested aerosol generation methods, indicating that residual solvent carried by the particles had no impact on the measurements.</p><p>To determine the evaporation coefficient, we developed the integrated volume - tandem differential mobility analysis (IV-TDMA) method. This thermodenuder-based method allows separate determination of the three parameters governing aerosol evaporation, namely, saturation pressure, surface free energy, and evaporation coefficient. Saturation pressure was determined using the IVM, while evaporation coefficient and surface free energy were determined by fitting particle evaporation rates measured under non-equilibrium conditions to a numerical model of the evaporation process. Evaporation coefficient was determined in a size range where surface free energy effects were negligible, allowing for single parameter optimization. We obtained evaporation coefficient and surface free energy values of 0.07 and 0.15 J/m2, 0.08 and 0.17 J/m2 and 0.24 and 0.23 J/m2 for C-4, -6, and -7 dicarboxylic acids, respectively.</p> en_US
dc.subject Environmental Engineering en_US
dc.subject en_US
dc.title Experimental Investigation of Thermodynamic and Kinetic Properties of Semi-volatile Organic Aerosols en_US
dc.type Dissertation en_US
dc.department Civil and Environmental Engineering en_US

Files in this item

This item appears in the following Collection(s)

Show simple item record