Thin Film Edge Emitting Lasers and Polymer Waveguides Integrated on Silicon

Jokerst, Nan M

Palit, Sabarni

2011-01-06T16:01:16Z

2012-01-01T05:30:13Z

2010

Electrical and Computer Engineering

The integration of planar on-chip light sources is a bottleneck in the implementation of portable planar chip-scale photonic integrated sensing systems, integrated optical interconnects, and optical signal processing systems on platforms such as Silicon (Si) and Si-CMOS integrated circuits. A III/V on-chip laser source integrated onto Si needs to use standard semiconductor fabrication techniques, operate at low power, and enable efficient coupling to other devices on the Si platform.

In this thesis, thin film strain compensated InGaAs/GaAs single quantum well (SQW) separate confinement heterostructure (SCH) edge emitting lasers (EELs) have been implemented with patterning on both sides of the thin film laser under either growth or host substrate support, with the devices metal/metal bonded to Si and SiO₂/Si substrates. Gain and index guided lasers in various configurations fabricated using standard semiconductor manufacturing processes were simulated, fabricated, and experimentally characterized. Low threshold current densities in the range of 250 A/cm2 were achieved. These are the lowest threshold current densities achieved for thin film single quantum well (SQW) lasers integrated on Si reported to date, and also the lowest reported, for thin film lasers operating in the 980 nm wavelength window.

These thin film EELs were also integrated with photolithographically patterned polymer (SU-8) waveguides on the same SiO₂/Si substrate. Coupling of the laser and waveguide was compared for the cases where an air gap existed between the thin film laser and the waveguide, and in which one facet of the thin film laser was embedded in the waveguide. The laser to waveguide coupling was improved by embedding the laser facet into the waveguide, and eliminating the air gap between the laser and the waveguide. Although the Fresnel reflectivity of the embedded facet was reduced by embedding the facet in the polymer waveguide, leading to a 27.2% increase in threshold current density for 800 &mum long lasers, the slope efficiency of the L-I curves was higher due to preferential power output from the front (now lower reflectivity) facet. In spite of this reduced mirror reflectivity, threshold current densities of 260 A/cm2 were achieved for 1000 &mum long lasers. This passively aligned structure eliminates the need for precise placement and tight tolerances typically found in end-fire coupling configurations on separate substrates.

https://hdl.handle.net/10161/3089

Engineering, Electronics and Electrical

heterogeneous integration

hybrid integration

photonic integrated circuits

polymer waveguides

thin film lasers

Thin Film Edge Emitting Lasers and Polymer Waveguides Integrated on Silicon

Dissertation

12